How to make a rc Tricopter
PLEASE WATCH THE VIDEO
This tricopter V2.6HV is built tricopter body but you can also build your tricopter design around the Anycopter Hub available in your web store.
Parts used in this build:
Parts used in this build:
1 x Tricopter frame (Alternative frame: Anycopter Hub)
1 x M3*20 screws + locknuts
1 x KK2 flight controller
1 x Male to male servo connectors
1 x 3 X 3.5mm bullet ESC Power Breakout Cable
3 x DT750 750kV Motors
3 x Hobbyking F20A Speed Controllers1 x 4s Turnigy 3000mAh LiPo1 x BMS-385DMAX Digital Servo (Metal Gear)1 x Gemfan 9x4.71 x Front wheel steering mounts1 x Male to male servo cables1 x M3x30 Hex screws (if building the camera tray)
1 x M4 lock nuts (for the DT750's)
1 x Distribution power adapter1 x Battery strap1 x Servo extension1 x 3.5 bullet connectors
1 x M3*20 screws + locknuts
1 x KK2 flight controller
1 x Male to male servo connectors
1 x 3 X 3.5mm bullet ESC Power Breakout Cable
3 x DT750 750kV Motors
3 x Hobbyking F20A Speed Controllers1 x 4s Turnigy 3000mAh LiPo1 x BMS-385DMAX Digital Servo (Metal Gear)1 x Gemfan 9x4.71 x Front wheel steering mounts1 x Male to male servo cables1 x M3x30 Hex screws (if building the camera tray)
1 x M4 lock nuts (for the DT750's)
1 x Distribution power adapter1 x Battery strap1 x Servo extension1 x 3.5 bullet connectors
(I have bought at local shops)
4 mm carbon fiber rod
40+ of 2.5mm zip-ties
1/16th plywood (if building the camera tray)
Blue locktite
CA glue
12mm (1/2 in.) Boom - (Poplar Square Dowel)
Boom Lengths:
Front: 35cm
Back: 37cm
No comments:
Post a Comment